EN
11_11. 6755532_02
If there are any oxidised parts, treat with paint
inspected at the factory. Under normal condi
-
related to control of refrigerant gas. Through
from the joints, causing refrigerant to escape
and discharge the circuit, causing appliance
points are to be discovered, repaired and the
December 28 1993 n°549 law.
The load procedure is the following:
using a vacuum pump connected to the
is read on the vacuum meter. Wait a few
minutes and check that this value does not
rise above 50 Pa.
Connect the refrigerant gas cylinder or
a load cylinder to the socket on the low
pressure line.
Load the amount of refrigerant gas indi-
cated on the appliance features plate.
that the liquid indicator indicates the dry
-
pletely before being re-loaded.
The R410A refrigerant must only be loaded
in the liquid state.
The sealing test or the search for leaks
must only be performed using R410A
refrigerant gas, checking using a suitable
leak detector.
In the cooling circuit it is prohibited to use
or poisonous gases because they are a
We recommend to envision a ma-
chine book (not supplied, but the
to keep track of the interventions
performed on the unit. In this way
it will be easy to suitably organise
the interventions making research
and the prevention of any machine
breakdowns easier.
Use the date to record date, type
of intervention made (routine
maintenance, inspection or re-
-
tion, measures actuated…
IT IS forbidden to RELOAD the
circuit with a refrigerant gas differ-
ent to the one indicated. Using a
different refrigerant gas can cause
serious damage to the compressor.
Envisions that disposal of the unit
is carried out in conformity with
the Standards in force in the differ-
ent countries
To Next Page
Loading...
