11
After connecting the serial cable, close the panel again by aligning the upper and lower bodies and pressing until the upper
body hooks up with the lower body.
5
Notes for installing the wired panel It is advised not to install the wired panel where it may
come into contact with water or direct sunlight; it is also advised to avoid installation too close
to sources of intense heat.
WARNING: MVA SYSTEMS MUST HAVE A MASTER ONLY ONE) FOR CORRECT MANAGE-
MENT OF THE OPERATING MODES.
FOR THE SETTING PROCEDURE, REFER TO THE SPECIFIC SECTION.
To Next Page
Loading...
Need help?
General
