AERMEC WRCB - X-Fan Setting

14
4.11 X-FAN SETTING
X-FAN function: After the unit is turned o, the water in evaporator of indoor unit will be automatically evaporated to avoid mildew.
In the Cooling or Dry mode, press FUNCTION till the unit enters the X-fan setting interface (X-FAN) and then press SWING/ENTER to active this function.
When the X-FAN function is activated, press FUNCTION to the X-fan setting interface and then press SWING/ENTER to cancel this function.
X-FAN function setting is as shown in Fig.13
Fig.13: X-fan Setting
Wi
Fi
Wi
Fi
Wi
Fi
Wi
Fi
Wi
Fi
Turn on the unit, without turning on X-fan
function
Press “FUNCTION” button into X-fan state Press “SWING/ENTER” button to turn
on X-fan function
Press “FUNCTION” button into X-fan state
Press “SWING/ENTER” button to turn
o X-fan function
Note:
1. When the X-FAN function is activated, if turning o the unit by pressing ON/OFF or by the remote controller, the indoor fan will run at the low fan speed for 2 min, with
“X-FAN” displayed on the LCD. While, if the X-FAN function is deactivated, the indoor fan will be turned o directly.
2. X-FAN function is unavailable in the Fan or Heating mode.