AERMEC WRCB - I-Demand Setting

17
4.14 I-DEMAND SETTING
I-Demand function: under this function the indoor air setting temperature in cooling mode is xed at 27°C.
I-Demand on: Press FUNCTION under on state of the unit till the unit enters the I-Demand setting interface. Press SWING/ENTER to conrm the setting.
I-Demand o: When the I-Demand function is activated, press FUNCTION to enter the I-Demand setting interface. After that, press SWING/ENTER to cancel this function.
 Note:
1. This function is only available in cooling mode.
2. When this function has been set, set temperature is displayed in SE. In this case, temperature setting and fan speed setting are shielded.
3. This function will be cancelled when switching modes.
4. This function and sleep function cannot be on simultaneously. If I-demand function is set rstly and then sleep/quiet function is set, I-demand function will be cancelled
while sleep function will be valid, and vice versa.
Fig. 16: I-Demand Setting
Wi
Fi
Wi
Fi
Wi
Fi
Wi
Fi
Wi
Fi
Turn on the unit,without turning on
I-demand function
Press “FUNCTION” button into
I-demand state
Press “SWING/ENTER” button to turn
on I-demand function
Press “FUNCTION” button into I-demand
state
Press “SWING/ENTER” button to turn
o I-demand function