To Next Page

To Previous Page

4.13 ABSENT SETTING

Absent on: Press FUNCTION under on state of the unit till the unit enters the Absent setting interface. Press SWING/ENTER to conrm the setting.

Absent o: When the Absent function is activated, press FUNCTION to enter the Absent setting interface. After that, press SWING/ENTER to cancel this function.

 Note:

1. This function is only available in heating mode.

2. When this function has been set, set temperature is displayed in 8°C(46°F). In this case, temperature setting and fan speed setting are shielded.

3. This function will be cancelled when switching modes.

4. This function and sleep function cannot be on simultaneously. If Absent function is set rstly and then sleep/quiet function is set, Absent function will be cancelled while

sleep function will be valid, and vice versa.

Fig. 15: Absent Setting

Turn on the unit,without turning on absent

function

Press “FUNCTION” button into absent state Press “SWING/ENTER” button to turn

on absent function

Press “FUNCTION” button into absent state

Press “SWING/ENTER” button to turn o

absent function