19
5 INSTALLATION AND DISMANTLEMENT
5.1 CONNECTION OF THE SIGNAL LINE OF THE WIRED CONTROLLER
— Open the cover of the electric control box of the indoor unit.
— Let the single line of the wired controller through the soleplate of wired controller.
— Connect the signal line of the wired controller to the 4-pin socket of the indoor unit.
— The communication distance between the main board and the wired controller can be up to 20 meters (the standard distance is 8 meters)
5.2 INSTALLATION OF THE WIRED CONTROLLER
Fig. 17: Accessories for the Installation of the Wired Controller
1 3 42
N° 1 2 3 4
Name Wired Controller Screw M4X25 Soleplate of the Wired Controller Socket box embedded in the wall
Fig. 18
1
2
Note: In the back side of the Wired Controller, it is possible to nd:
— CN1, which is RS485 communication interface and is used for connecting the panel to the unit using a 4-core communication wire;
— CN2 and CN3, which are used for connecting the CC2 Accessory if desired.
There is no sequence for these two needle stands. You can connect one or two needle stand(s) basing on the requirement.
Fig. 18 shows the installation steps of the wired controller, please pay attention to the following notes:
1. Prior to the installation, please rstly cut o the power supply of the wire buried in the installation hole, that is, no operation is allowed with electricity during the whole
installation.
2. Pull out the four-core twisted pair line from the installation holes and then let it go through the rectangular hole behind the soleplate of the wired controller.
3. Stick the soleplate of wired controller on the wall and then use screw M4×25 to x soleplate and installation hole on wall together
4. Insert the four-core twisted pair line into the slot of the wired controller.
5. Buckle the front panel and the soleplate of the wired controller together.
For matching with dierent models, the patch cord and the connection wire are provided in the packaging box of wired controller. As shown in g. 19.
To Next Page
Loading...
