What to do if Afore Inverter shows Over Temperature Fault?
If your Afore Inverter displays an 'Over Temperature Fault', it may be due to the inverter enclosure being too hot or a temperature sensor fault. Turn off the inverter and allow it to cool down to a normal temperature. Consider relocating the inverter to a well-ventilated area. If the problem persists, the temperature sensor may need to be replaced.
Why does my Afore Inverter show a Ground Current Fault?
A 'Ground Current Fault' on your Afore Inverter can occur due to poor earthing leading to high leakage current, or if the PV(+) or PV(-) is earthed. To address this: 1. Check the AC output wiring and restart the inverter. 2. Check the PV array wiring.
How to resolve PV Over Fault on Afore Inverter?
A 'PV Over Fault' on your Afore Inverter typically indicates that the PV array's Voc (open-circuit voltage) is too high. You should re-design the PV array configuration. Also, measure the PV array voltage to ensure it matches what the inverter displays.
Lists essential safety precautions for inverter installation and operation.
Provides guidelines for choosing a suitable location for inverter installation.
Details the steps for mounting the inverter using the provided wall bracket.
Details how to connect the inverter to the AC grid and RS485 communication port, including conditions.
Details the procedures for connecting the inverter to the PV generator, including conditions and connector assembly.
Lists common error messages, their causes, and recommended corrective actions.
To Next Page
General