AGFA ANAPURNA M4F - Page 58

:Anapurna M4F - Operator Manual Stay ahead. With Agfa Global Services.
58 APPENDIX 2 - Key Operator training checklist
APPENDIX 2. Key operator training checklist.
(Thisdocumentisanoverviewofalltopicsthatshouldbeexplainedclearlybyacertiedengineertoan
operator.Ifalltopicsarechecked,thekeyoperatoriscertiedtoworkwiththe:AnapurnaM4F).
A. INFORMATION.
1. Safety Instructions.
a. Anapurna Engine.
 KnowtheEmergency‘Stop’buttons.
 Makesurethatthe‘SafetySensors’areworking(turned‘ON’).
(While at OFFLINE Mode, Press F4 & then F2).
 Before printing, make sure no one is around the engine.
 Afterprinting,alwaysputtheengineto‘OFFLINE’.
b. UV Light.
 Do not look directly into the UV Light when printing.
 Don’t expose your skin directly to UV light.
 If you need to look at the direction of the light, wear protective glasses.
c. UV Inks.
 UV Inks (and waste) are chemicals, when handling the ink, wear
protective gloves to protect your skin. Also wear protective glasses
to avoid splashes.
 Storage of inks. Ideal between 4° & 10° C. No more than 25° C at any time
 Shelf Life of inks.
 Takecarewhenllingthemaininktank/cleaningtank.
 Keep waste separate from the ink bottles.
 Dispose off waste as per local council regulations.
 Never mix solvent waste or aqueous waste with UV waste (as per local
council regulations).
2. Printer Overview.
a. Terminologies used (Home Side, Purge side or Capping side etc).
b. Anapurna Shuttle (carriage) Layout.
 Print Heads, sub tanks etc.
 2 way ink valves / solution valve.
 UV Lamps.
c. Purge Button (Ink), Flushing Button (Cleaning Solution).
  d. NegativeVacuum‘Gauge’&‘DigitalIndicator’.
e. Ink Supply System.
B. OPERATIONS.
1. Wasatch SoftRIP AE.
a. Wasatch basics.
 Printing Modes (4 pass, 8 pass, bi-dir, uni-dir).
 ImagingCongurations.
 Media Width.
b. Ripping & Printing.
 Supported File formats.
 File preparation: size, scale, crop, mirror, rotate, tiling.
 SelectionofcorrectImagingConguration(printmode).
 Sending to Rip Queue (Or Rip & Print).
c. Advanced settings (Wasatch SoftRIP AE manual).
 Color related info (color curves, color replacement,...).
 Use of ink restrictiona and ink limits.
 SettingupanImagingcongurations(thestandardAgfacongurations).
 Print Strategies (immediate printing, manual layout,...).
 Hot folder set-up.
d. Hardware setup (Wasatch SoftRIP AE manual).
 Do not load any design software (DTP applications).
 Never download anything from the internet.
All boxes
should be
checked by
the operator.