AgfaPhoto Optima 147 - PictBridge Printing Options (Continued)

68 69
AgfaPhoto OPTIMA 147 AgfaPhoto OPTIMA 147
68 69
AgfaPhoto OPTIMA 147 AgfaPhoto OPTIMA 147
Connecting the camera and printer.
1. Make sure both the camera and printer are turned on.
2. Connect one end of the supplied USB cable to the USB
port on your camera.
3.
Connect the other end of the cable to the USB port on
the printer.
If the camera is not connected to a PictBridge compatible
printer, the following error message will appear on the LCD
screen.
The above error message will also appear if the USB
mode were set incorrectly, in which case you should
disconnect the USB cable, check the USB mode
settings, ensure that the Printer is turned on, and
then try connecting the USB cable again.