Using and Updating the Logic Analysis System 6
16900 Series Logic Analysis Systems Installation Guide 123
3 For the interface card location you will be using, using a Torx T10
screwdriver, remove the screw securing the slot cover; then, remove the
slot cover.
4 Insert the interface card into the appropriate slot:
a Ensure that the tab on the board’s rear panel is aligned with the slot
in the deck.
b Press the board securely into the socket on the motherboard.
c Replace the screw.
5 Replace the cover.
When reinstalling the handle assembly, ensure that the screws are torqued to 2.372
Newton meters (21 inch pounds) so that they do not work themselves loose.
To Next Page
Loading...
