Frequency-Shift Keying (FSK) Commands
(see page 167 for more information)
[SOURce:]
FSKey:FREQuency {<
frequency>|MINimum|MAXimum}
FSKey:FREQuency? [MINimum|MAXimum]
FSKey:INTernal:RATE {<
rate in Hz>|MINimum|MAXimum}
FSKey:INTernal:RATE? [MINimum|MAXimum]
FSKey:SOURce {
INTernal|EXTernal}
FSKey:SOURce?
FSKey:STATe {OFF|ON}
FSKey:STATe?
Sweep Commands
(see page 170 for more information)
[SOURce:]
FREQuency:STARt {<frequency>|MINimum|MAXimum}
FREQuency:STARt? [MINimum|MAXimum]
FREQuency:STOP {<
frequency>|MINimum|MAXimum}
FREQuency:STOP? [MINimum|MAXimum]
[SOURce:]
SWEep:SPACing {
LINear|LOGarithmic}
SWEep:SPACing?
SWEep:TIME {<
seconds>|MINimum|MAXimum}
SWEep:TIME? [MINimum|MAXimum]
SWEep:STATe {OFF|ON}
SWEep:STATe?
TRIGger:SOURce {
IMMediate|EXTernal|BUS} Triggered Sweep Mode
TRIGger:SOURce?
Default parameters are shown in bold.
Chapter 4 Remote Interface Reference
SCPI Command Summary
130
To Next Page
Loading...
