Execution Errors
-101 Invalid character
An invalid character was found in the command string. You may have
inserted a character such as #, $, or % in the command header or within
a parameter. Example: TRIG:SOUR BUS#
-102 Syntax error
Invalid syntax was found in the command string. You may have
inserted a blank space before or after a colon (or before a comma) in the
command header. Example: APPL:SIN ,1
-103 Invalid separator
An invalid separator was found in the command string. You may have
used a comma instead of a colon, semicolon, or blank space – or you may
have used a blank space instead of a comma. Example: TRIG:SOUR,BUS
or APPL:SIN 1 1000
-105
GET not allowed
A Group Execute Trigger (GET) is not allowed within a command string.
-108 Parameter not allowed
More parameters were received than were expected for the command.
You may have entered an extra parameter, or you added a parameter to
a command that does not accept a parameter. Example: APPL? 10
-109 Missing parameter
Fewer parameters were received than were expected for the command.
You omitted one or more parameters that are required for the command.
Example: OUTP:LOAD
-112 Program mnemonic too long
A command header was received which contained more than the
maximum 12 characters allowed. Example: OUTP:SYNCHRONIZATION ON
5
Chapter 5 Error Messages
Execution Errors
229
To Next Page
Loading...
