To set the GPIB address
Each device on the GPIB (IEEE-488) interface must have a unique
address. You can set the function generator’s address to any value
between 0 and 30. The address is set to 10 when the function generator is
shipped from the factory. The current address is displayed momentarily
on the front panel when you turn on the function generator. See also
“GPIB Address,” on page 114.
1 Turn on the menu.
A: MOD MENU
2 Move across to the
I/O MENU choice on this level.
E: I/O MENU
3 Move down a level to the
HPIB ADDR command.
1: HPIB ADDR
4 Move down to the “
PARAMETER” level to set the address.
Use the left/right and down/up arrow keys to change the address.
¾10 ADDR
5 Save the change and turn off the menu.
The address is stored in non-volatile memory, and does not change when
power has been off or after a remote interface reset.
Menu On/Off
Shift
<
<
¿
¿
Enter
4
Chapter 4 Remote Interface Reference
To set the GPIB address
217
To Next Page
Loading...
Need help?
General
