Agilent Technologies 33120A User Manual

Frequency-Shift Keying (FSK) Commands
See also “FSK Modulation,” starting on page 90 in chapter 3.
FSK Overview
The following is an overview of the steps required to generate an
FSK waveform. The commands used for FSK are listed on the next page.
1 Set up the carrier waveform.
Use the APPLy command or the equivalent FUNC:SHAP, FREQ, VOLT,
and VOLT:OFFS commands to select the function, frequency, amplitude,
and offset of the carrier waveform. You can select a sine, square,
triangle, ramp, or arbitrary waveform for the carrier.
2 Select the FSK “hop” frequency.
Use the FSK:FREQ command to set the “hop” frequency.
3 Set the FSK rate.
Use the FSK:INT:RATE command to set rate at which the output
frequency “shifts” between the carrier frequency and the hop frequency
(internal FSK source only).
4 Select the FSK source.
Select an internal or external
FSK source using the FSK:SOUR command.
5 Enable FSK modulation.
After you have set up the other
FSK parameters, use the FSK:STAT ON
command to enable
FSK modulation.
4
Chapter 4 Remote Interface Reference
Frequency-Shift Keying (FSK) Commands
167

Agilent Technologies 33120A Specifications

General

Brand	Agilent Technologies
Model	33120A
Category	Inverter
Language	English