*RCL {0|1|2|3}
Recall a previously stored state. To recall a stored state, you must use
the same memory location used previously to store the state.
You cannot recall the instrument state from a memory location that
was not previously specified as a storage location. For example, an
error is generated if you attempt to recall from memory location “2”
but have never stored to that location. From the remote interface, a
+810, “State has not been stored” error is generated if nothing is stored
in the specified memory location.
MEMory:STATe:DELete {0|1|2|3}
Delete a previously stored state and clear the memory location.
If nothing is stored in the specified memory location, a +810, “State has
not been stored” error is generated.
*OPC
Set the “operation complete” bit (bit 0) in the Standard Event register
after the previous commands have been executed. Used only in the
triggered burst mode and triggered sweep mode.
*OPC?
Return “1” to the output buffer after the previous commands have
been executed. Used only in the triggered burst mode and triggered
sweep mode.
*WAI
Wait for all pending operations to complete before executing any
additional commands over the interface. Used only in the triggered burst
mode and triggered sweep mode.
Chapter 4 Remote Interface Reference
System-Related Commands
192
To Next Page
Loading...
