CALibration:SETup <0|1|2|3| . . . |84>
Configure the function generator’s internal state for each of the
calibration steps to be performed.
CALibration:SETup?
Query the calibration setup number. Returns a value between 0 and 84.
CALibration:STRing <
quoted string>
Record calibration information about your function generator.
For example, you can store such information as the last calibration
date, the next calibration due date, the instrument serial number,
or even the name and phone number of the person to contact for a new
calibration. [ Stored in non-volatile memory ]
You can record information in the calibration message only from the
remote interface. However, you can read the message from either the
front-panel menu or the remote interface.
The calibration message may contain up to 40 characters. However,
the function generator can display only 11 characters of the message
on the front panel (additional characters are truncated).
CALibration:STRing?
Query the calibration message and return a quoted string.
CALibration:VALue <
value>
Specify the value of the known calibration signal used by the calibration
procedure. Use the CAL:SET command to configure the function
generator’s internal state for each of the calibration steps to be performed.
CALibration:VALue?
Query the present calibration value.
Chapter 4 Remote Interface Reference
Calibration Commands
194
To Next Page
Loading...
Need help?
General
