*OPC
Set the “operation complete” bit (bit 0) in the Standard Event register
after the previous commands have been executed. Used only in the
triggered burst mode and triggered sweep mode.
*OPC?
Return “1” to the output buffer after the previous commands have
been executed. Used only in the triggered burst mode and triggered
sweep mode.
*PSC {0|1}
Power-on status clear. Clear the Status Byte and Standard Event
register enable masks when power is turned on (*PSC 1). When
*PSC 0 is in effect, the Status Byte and Standard Event register enable
masks are not cleared when power is turned on. The factory setting is
“1” (enabled). [ Stored in non-volatile memory ]
*PSC?
Query the power-on status clear setting. Returns “0” (*PSC 0) or “1”
(*PSC 1).
*SRE <
enable value>
Enable bits in the Status Byte enable register.
*SRE?
Query the Status Byte enable register. The function generator returns
a decimal value which corresponds to the binary-weighted sum of all
bits set in the register.
*STB?
Query the Status Byte summary register. The *STB? command is
similar to a serial poll but it is processed like any other instrument
command. The *STB? command returns the same result as a serial poll
but the “request service” bit (bit 6) is not cleared if a serial poll has
occurred.
*WAI
Wait for all pending operations to complete before executing any
additional commands over the interface. Used only in the triggered burst
mode and triggered sweep mode.
Chapter 4 Remote Interface Reference
Status Reporting Commands
210
To Next Page
Loading...
Need help?
General
