Agilent Technologies 33120A - Page 225

Device-Specific Commands The following commands are designed
specifically for the 33120A. They are not included in the 1993.0 version
of the
SCPI standard. However, these commands are designed with the
SCPI standard in mind and they follow all of the command syntax rules
defined by the standard.
CALibration
:COUNt?
:SECure:CODE <new code>
:SECure:STATe {OFF|ON},<code>
:SECure:STATe?
:SETup <0|1|2|3|
. . . |84>
:SETup?
:STRing <quoted string>
:STRing?
DATA
:ATTRibute:AVERage? <arb name
>
:ATTRibute:CFACtor? <
arb name>
:ATTRibute:POINts? <
arb name>
:ATTRibute:PTPeak? <
arb name>
:DAC VOLATILE, {<
binary block>|<value>,<value>, . . .}
:NVOLatile:CATalog?
:NVOLatile:FREE?
OUTPut
:LOAD {50|INFinity|MINimum|MAXimum}
:LOAD? [MINimum|MAXimum]
:SYNC {OFF|ON}
:SYNC?
MEMory:STATe:DELete {0|1|2|3}
[SOURce]
:AM:INTernal:FUNCtion {SINusoid|SQUare|TRIangle|RAMP|NOISe|USER}
:AM:INTernal:FUNCtion?
:APPLy:SINusoid [<frequency> [,<amplitude> [,<offset>] ]]
:APPLy:SQUare [<frequency> [,<amplitude> [,<offset>] ]]
:APPLy:TRIangle [<frequency> [,<amplitude> [,<offset>] ]]
:APPLy:RAMP [<frequency> [,<amplitude> [,<offset>] ]]
:APPLy:NOISe [<frequency|DEFault>
[,<amplitude> [,<offset>] ]]
:APPLy:DC [<frequency|DEFault>
[,<amplitude|DEFault> [,<offset>] ]]
:APPLy:USER [<frequency> [,<amplitude> [,<offset>] ]]
:APPLy?
Non-SCPI Commands
4
Chapter 4 Remote Interface Reference
SCPI Conformance Information
223