Site Preparation Checklist
4 Agilent 5100 and 5110 ICP-OES Site Preparation Guide
Site Preparation Checklist
Your site must meet all requirements before you request installation.
Complete each requirement listed in the table. After completing each
requirement, place a check in the appropriate check box. Ensure you
compare the boxes with the shipping list supplied with the boxes.
Requirements
Principal installation area is in compliance with all relevant safety regulations.
Laboratory temperature is maintained between 15-30°C (59-86°F)
Laboratory is free of excessive particulate matter.
Cooling air system is set up (if required).
Workbench requirements are met.
Sufficient bench space is available for all components.
Bench can support system weight.
Personal computer with Microsoft Windows 7 Professional 64-bit SP1 installed and printer is set up, if
purchased separately.
Entrance to the lab is at least 1050 mm (41.3 in) wide for packaged instrument, or 800 mm (31.5 in) wide for
unpackaged instrument.
Exhaust system is suitable.
Specified electrical supply and power outlets are installed.
Gas supply (at specified purity), regulator, and gas lines are installed for argon and any allowed optional
gases.
Water cooling/circulation system and power connections are set up, if system is not purchased from
Agilent.
Waste container appropriate for the chemical waste is prepared.
Accessories
SPS 4 Autosampler
SPS 3 Sample Preparation System
Advanced valve system (AVS) 4, 6, or 7 Switching Valve
SVS 2+ Productivity Package
VGA Vapor Generation Accessory
5 Channel Peristaltic Pump
Air Inlet Duct Filter
External Inlet Duct Adapter
Multimode Sample Introduction System (MSIS)
Argon Saturator Accessory (ASA)
To Next Page
Loading...
Need help?
General
