3-21.
Table 3-2
shows the program steps used to modify
Table 4-12
in the HP 5501A Laser Transducer Operating
and Service Manual. The program uses the HP 10760A x-axis card to monitor the laser warmup.
3-22.
Table 3-3
shows the program steps used to modify
Table 4-13
in the system manual. The program is for a two-
axis system with the HP 1074f>A in 16-bit mode and using positive-true logic. The program uses the x-axis card to
monitor the laser warmup.
3-23.
Tables 3-4
and
3-5
are complete listings of the modified versions of
Tables 4-12
and
4-13
found in the HP
5501A Laser Transducer Operating and Service Manual.
To Next Page
Loading...
