Introduction
Agilent 5800 and 5900 ICP-OES User's Guide 15
2 Introduction
Site Preparation Requirements 15
User Documentation 15
ICP-OES Argon Gas Supply 16
Exhaust System 17
ICP-OES Instrument Cooling Air Supply 17
Water Chiller System 18
Drain Vessel 18
Site Preparation Requirements
Prior to receiving your instrument, you will have been provided with an Agilent
5800 and 5900 ICP-OES Site Preparation Guide, which describes the
environmental and operating requirements of the ICP-OES system. You must
prepare your laboratory according to these instructions before the ICP-OES can be
installed. You should keep the Site Preparation Guide for future reference for
example, if you plan to move your instrument. If you have misplaced your copy,
you can obtain a free replacement from your local Agilent office.
Position the equipment for easy access to the disconnecting switch on the left
side of the instrument.
User Documentation
You have been provided with the following documentation to help you set up and
operate your Agilent ICP-OES system:
This User’s Guide, with safety practices and hazards information, instructions
for finding information about installing and maintaining the components of the
ICP-OES and a brief operation overview.
To Next Page
Loading...
Need help?
General
