Agilent Technologies 5800 User Manual

Installation
Agilent 5800 and 5900 ICP-OES User's Guide 23
 Green blinking fast (2 Hz). Mains power module failed its initialization power-
up self-check, instrument is unusable. The mains power supply is not
adequate or the internal mains module needs to be replaced.
 Green constantly on indicates the instrument is switched on.
ICP Expert Software
The Agilent-trained, Agilent-qualified or Agilent-authorized field service engineer
will install the ICP Expert software for you during the installation process.
However, you may need to install the software yourself at some later stage, for
example if you change the PC. Instructions are provided.
There are several installation scenarios:
 Standalone or network Flat File
 Standalone or network Database for 21 CFR Part 11 installations
 Upgrading Standalone or Network Database ICP Expert installations
Installation includes:
 Installing the ICP Expert software
 Installing the ICP Expert Help
 Installing the LAN cable
 Setting the instrument IP address
 Installing and configuring SDA for 21 CFR Part 11 compliance
 Installing and configuring SCM for 21 CFR Part 11 compliance
 Completing a dark current scan and wavelength calibration
For instructions on how to install your ICP Expert software, refer to the
documentation provided with your software:
 ICP Expert Software Installation Instructions
 ICP Expert Software Installation Instructions for 21 CFR Part 11 Environments
Once you have installed the appropriate software, connect the Ethernet cable, set
the instrument IP address if necessary, and then perform the Detector Calibration
and Wavelength Calibration.

Agilent Technologies 5800 Specifications

General

Brand	Agilent Technologies
Model	5800
Category	Laboratory Equipment
Language	English