Introduction
Agilent 7100 CE in Empower Environment 3
Introduction
Waters Instrument Control Software (ICS) is Waters Corporation’s
adoption of the Agilent Instrument Control Framework (ICF) for their data
systems. This guide describes how to configure and use the 7100 Capillary
Electrophoresis (CE) in Waters Empower environment.
Empower 3 offers all key functions to control the G7100A Agilent Capillary
Electrophoresis system. All established techniques are feasible, such as the
use of direct and indirect detection modes, use of special electrolyte
systems (containing micelles or gel matrices) and also capillary isoelectric
focusing (cIEF) or capillary electrochromatography (CEC). The application
of external high pressure is supported.
For data analysis, Empower offers processing tools for peak integration
and calculation of concentrations in CE specific mode.
Table 1 Supported and unsupported configurations using CE in Empower
Waters Instrument
Control Packages
Agilent ICF/
Agilent LC Driver
CE support in Waters Empower 3
ICF Support v2.2
#667005584
A.02.04
A.02.14
Supported
G7100A Capillary Electrophoresis, with the
internal components:
G7150A CE Mainframe
G7151A DAD
Min. Firmware B.06.73 (older firmware does
not support the use of RFID Tags for the DAD
UV-Lamp)
Not supported
G1600 Capillary Electrophoresis
ICF Support v2.2
#667005449
A.02.03 DU2
A.02.13
Not supported
G7100A Capillary Electrophoresis
G1600A Capillary Electrophoresis
And any lower integration
To Next Page
Loading...
