Operation Guide
Syringes
16
Installing A Syringe
To install a syringe:
1. Disconnect the injector cable from the GC and lay the injector on its back
on a flat surface.
2. Open the injector door.
3. Slide the syringe carriage up (or down) until the syringe is accessible. See
Figure 10.
4. Pass the syringe needle through the hole in the needle support foot.
5. Align the syringe barrel with the flange guide and syringe clip and press the
syringe into place, keeping the needle in the hole of the needle support foot.
6. Close the syringe latch by swinging it clockwise.
Figure 10 Installing the syringe
Flange
Plunger carrier loop
Plunger screw
Flange guide
Syringe latch
Syringe clip
Needle support foot
Slide
Syringe carrier
Plunger
Syringe
Needle
To Next Page
Loading...
