18 Maintenance
2 Removing Covers and Components
To Remove the Loop Cover
1 Gather the following:
• T- 20 Torx driver
2 Remove the pneumatics front cover. See “To Remove the
Pneumatics Front Cover”.
3 Remove the valve thermal enclosure. See “To Remove the
Valve Thermal Enclosure”.
4 Completely loosen the T- 20 Torx captive screw on the
loop cover (Figure 10).
Figure 10 Loop cover
5 Remove the loop cover.
Reinstallation is the reverse of these steps.
To Next Page
Loading...
