24 Operating Guide
2 Operating Basics
Correcting Problems
If the GC stops operation because of a fault, for example a
flow module shutdown after running out of carrier gas, do
the following:
1 Use the software keyboard or data system to stop the
alert tone. Click [Clear] on the software keyboard or turn
off the offending component in the data system. (For
details on the software keyboard, see “Software Keypad
Operation”.)
2 Resolve the problem, for example, by changing gas
cylinders or fixing the leak. See the Troubleshooting
Guide for details.
3 Once the problem is fixed, you may need to either power
cycle the instrument, or use the software keyboard or
data system to turn the problem component off, then on
again. For shutdown errors, you will need to do both.
To Next Page
Loading...
Need help?
General
