Software Keypad Operation 3
Operating Guide 31
The Software Keypad
Use the software keypad to:
• Operate the GC without an Agilent data system
• View instrument error conditions
• Prepare the GC for maintenance
• Clear fault conditions
The software keypad can control only one 7820A Series GC
at a time. It can connect to any 7820A GC on the PC’s
network.
To connect to a GC
1 Go to Connection > Connect.
2 Select IP to enter/select an IP address, or Name to select a
GC using a previously assigned name.
3 From the Targ et list, either enter or select the GC IP
address or name.
Use only one software keypad at a time to connect to a given GC.
To Next Page
Loading...
