SCPI COMMAND SUMMARY
SWEep:STEP
value is
(StopMAX-StartMIN)/10
SWEep:TIME MINimum
SWEep:TIME:AUTO ON
SWEep:TIME:LLIMit 10 ms
SWEep:GENeration ANALog
SWEep:MODE AUTO
SWEep:MANual:POINt 1
SWEep:MANual[:RELative] 0.50
SWEep:MARKer:STATe OFF
SYSTem:ALTernate 1
SYSTem:ALTernate:STATe OFF
SYSTem:COMMunicate:GPIB:ADDRess 19
SYSTem:MMHead:SELect:AUTO ON
SYSTem:SECurity:COUNt 1
UNIT:AM PCT *UNIT:POWer DBM
*SAV <num>
The present instrument state is stored in the sp ecied memory
register. The acceptable numeric range is from 1 to 8. An execution
error o ccurs if you try to save state 0.
*SRE <num>
*SRE?
Sets and queries the value of the Service Request Enable Register.
*STB?
Queries the Status Byte. This is a non-destructive read.
*TRG
This command performs the same function as the Group Execute
Trigger command dened by IEEE 488.1.
*TST?
A full selftest is p erformed, without data logging or lo oping, and
returns one of the following error co des:
Error Co de Denition
0 Test passed.
1 Test failed.
2 Test not run yet. (This is an unlikely event.)
3 Test ab orted.
4 Can not execute the test.
5 Can not execute the test, test skipped.
0
1 Unrecognized result, software defect.
Operating and Programming Reference S-17
To Next Page
Loading...
Need help?
General
