Changing the Preset
Parameters
1. Set up the swept signal generator in the desired op eration state to
be used as the preset state.
2. Refer to menu map 8.
3. Press SYSTEM
4
MENU
5
.
4.
Select
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Save User Preset
.
5.
Select
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Preset Mode User
.
Whenever the
4
PRESET
5
key is pressed, the swept signal generator will
return to the op eration state setup and saved in steps 1 and 4. The
swept signal generator displays:
*** USER DEFINED PRESET RECALLED ***
and also gives you the option of selecting the factory preset state by
creating a factory preset softkey.
1-54 Getting Started Advanced
To Next Page
Loading...
Need help?
General
