General Information and Safety Practices and Hazards
10 Agilent Cary 3500 UV-Vis Spectrophotometer User’s Guide
CE Compliance
Your Agilent Cary UV spectrophotometer has been designed to comply with the
requirements of the Electromagnetic Compatibility (EMC) Directive and the Low
Voltage (electrical safety) Directive (commonly referred to as the LVD) of the
European Union. Agilent has confirmed that each product complies with the
relevant Directives by testing a prototype against the prescribed EN (European
Norm) standards.
Proof that a product complies with these directives is indicated by:
the CE Marking appearing on the rear of the product, and
the documentation package that accompanies the product containing a copy
of the Declaration of Conformity. The Declaration of Conformity is the legal
declaration by Agilent that the product complies with the directives listed
above, and shows the EN standards to which the product was tested to
demonstrate compliance.
Electromagnetic Compatibility
EN55011/CISPR11
Group 1 ISM equipment: group 1 contains all Industrial, Scientific and Medical
(ISM) equipment in which there is intentionally generated and/or used
conductively coupled radio- frequency energy which is necessary for the internal
functioning of the equipment itself.
Class A equipment is equipment suitable for use in all establishments other than
domestic and those directly connected to a low voltage power supply network
which supplies buildings used for domestic purposes.
This device complies with the requirements of CISPR11, Group 1, Class A as
radiation professional equipment. Therefore, there may be potential difficulties in
ensuring electromagnetic compatibility in other environments, due to conducted
as well as radiated disturbances.
Operation is subject to the following two conditions:
1 This device may not cause harmful interference.
2 This device must accept any interference received, including interference that
may cause undesired operation.
To Next Page
Loading...
