Agilent Technologies E4980A - DC Bias Adjustment; DC Level V Monitor Adjustment; DC Level I Monitor Adjustment; DC Source Adjustment

24 Chapter 3
Adjustment
Required Adjustment after Replacing Assembly
DC Bias Adjustment
The purpose of this procedure is to adjust the DC Bias level.
DC Level V Monitor Adjustment
The purpose of this procedure is to adjust the DC Level Monitor.
DC Level I Monitor Adjustment
The purpose of this procedure is to adjust the DC Level I Monitor.
DC Source Adjustment
The purpose of this procedure is to adjust the DC Source level.
DCR Adjustment
The purpose of this procedure is to adjust the DCR measurement.
Impedance Adjustment
The purpose of this procedure is to adjust the impedance measurement.
AC Level Monitor Adjustment
The purpose of this procedure is to adjust the AC level monitor.
OSC Level Adjustment
The purpose of this procedure is to adjust the OSC level.