Agilent Technologies E4980A - Required Tools

Chapter 6 89
Replacement Procedure
Required Tools
6. Replacement Procedure
Required Tools
The following tools are required for repair of E4980A.
Table 6-1 Required Tools
Assembly Torque screwdriver Box torque wrench
T6 T8 T10 T20 5.5 mm 7 mm 3/8 in. 5/8 in.
3/4 Rack Module Top 
A3 Analog Daughter Board  
A2 Analog Board    
Front Panel Assembly    
Option Interface 
PPMC PCA  
A1 Mother Board    
Power Supply Assembly     
Base Plate      
Rear Panel Assembly      
FAN Assembly 
GPIB Cable  
Power Inlet Assembly    
PCA E4980 USB 
Binding Post Sgl     
Inverter     
Front Panel, Key Pad, and Key Flex
Circuit
   
Display Interface     