Agilent Technologies E5061B - Page 35

34 Chapter 2
Troubleshooting
Troubleshooting Using Diagnostic Test
test, replace the faulty board assembly as shown in Table 2-3.
Table 2-3 Diagnostic tests failure troubleshooting information (Option 3L5)
Test
No.
Test group Failured
Test
Probable faulty board assembly
A1/A11
Source
Module
A2
Receiver
Module
A9 LF
Source
Bias
Module
1 DC-BUS Test ALL ### ##
A1/A11
Source
Module
### # #
A2
Receiver
Module
### #
A9 LF
Source
Bias
Module
# ###
2 Internal Level Monitor Test ALL ## ### ##
A1/A11
Source
Module
### # #
3 RF Output Level Range Test ### # #
4 RF Output Level Power Sweep
Test
### # #
5 Receiver Absolute Measurement
Test
# ### #
6 Receiver Compression Test # ### #
7 Receiver IF Ranging Test # ### #
8 Gain-Phase Absolute
Measurement Test
# ### #