Agilent InfinityLab LC Series VWD User Manual 179
12 Hardware Information
Interfaces
• CAN connectors as interface to other modules
• LAN connector as interface to the control software
• RS-232C as interface to a computer
• USB (Universal Series Bus) as interface to a computer
• REMOTE connector as interface to other Agilent products
• Analog output connector(s) for signal output
Fraction Collectors
G7158B 2 Yes Yes No No E
G7159B 2 Yes Yes No No E
G7166A 2 No No No No No Requires a host module
with on-board LAN with
minimum FW B.06.40 or
C.06.40, or with addi-
tional G1369C LAN Card
G1364E/F, G5664B 2 Yes Yes No No E THERMOSTAT for
G1330B
Others
G7116A/B 2 No No No No No Requires a HOST mod-
ule via CAN
G7122A No No No Yes No A
G7170B 2 No No No No No Requires a host module
with on-board LAN with
minimum FW B.06.40 or
C.06.40, or with addi-
tional G1369C LAN Card
Table 16 Agilent InfinityLab LC Series Interfaces
Module CAN USB LAN
(on-board)
RS-232 Analog APG (A)
/ ERI (E)
Special
The detector (DAD/MWD/FLD/VWD/RID) is the preferred access point for
control via LAN. The inter-module communication is done via CAN.
To Next Page
Loading...
Need help?
General
