Instructions for Use
General Information
MS40+ Single Stage Rotary Vane Pumps User Manual / 87-901-008-01 (H.00) 48/104
General Information
This equipment is destined for use by professionals. The user should
read this instruction manual and any other additional information
supplied by Agilent before operating the equipment. Agilent will not be
held responsible for any events occurring due to non-compliance, even
partial, with these instructions, improper use by untrained persons,
non-authorized interference with the equipment or any action contrary
to that provided for by specific national standards.
MS40+ Single Stage Rotary Vane Pumps are single-stage oil-sealed rotary
vane pumps controlled by an electronic module.
These high vacuum pumps are suitable for pumping non corrosive gases.
The following paragraphs contain all the information necessary to
guarantee the safety of the operator when using the equipment. Detailed
information is supplied in the appendix "Technical Information".
This manual uses the following standard protocol:
WARNING!
The warning messages are for attracting the attention of the operator to a
particular procedure or practice which, if not followed correctly, could lead to
serious injury.
CAUTION!
The caution messages are displayed before procedures which, if not followed,
could cause damage to the equipment.
NOTE
The notes contain important information taken from the text.
To Next Page
Loading...
Need help?
General
