Technical Information
Caution Notes
MS40+ Single Stage Rotary Vane Pumps User Manual / 87-901-008-01 (H.00) 75/104
Caution Notes
a Before putting the pump back into operation after a breakdown, inspect it and check
carefully for any other signs of damage.
b Use only tools that are in perfect working order and specially designed for the job; use of
inappropriate or ineffective tools may cause serious damage.
c Always check the lubricant and that it is properly distributed through the pump;
inadequate lubrication may damage the pump seriously.
d Give the parts some form of marking as you strip them down to ensure that you
reassemble them again in the proper order.
e Check that there are no scratches or grooves on the machined shafts, in their seats
inside the pump or on machine-ground surfaces. Slight scratches and abrasions may be
eliminated with very fine emery paper or by a little light grinding.
f Before putting a group together, always spread a little oil over inner parts and mating
surfaces. Replace all seals with original spare parts before reassembling components.
To Next Page
Loading...
Need help?
General
