Technical Information
Starting and Running the Pump
MS40+ Single Stage Rotary Vane Pumps User Manual / 87-901-008-01 (H.00) 71/104
Starting and Running the Pump
WARNING!
The pump is designed for operation with neutral or non-corrosive fluids. It is
absolutely forbidden to use potentially explosive or flammable substances.
NOTE
If the pump is started with cold oil, initially more than normal noise will be
heard; this will last for a few minutes only until the oil reaches its working
temperature.
T
here are no special instructions for normal operation of the pump,
which is delivered to you after completion of a running cycle in the
factory.
NOTE
To allow the pump starting you have to wire properly the interlock pins by
connecting the mating connector provided with the pump.
NOTE
For repetitive work cycles, with brief time intervals in between, it is better not to
stop the pump.
To Next Page
Loading...
