Instructions for Use
Installation
MS40+ Single Stage Rotary Vane Pumps User Manual / 87-901-008-01 (H.00) 53/104
WARNING!
During installation, pay maximum attention that the suction flange is
connected to the vacuum chamber and the exhaust flange is not closed (see
the following figure). The pump must not be used as a compressor.
Non-observance of these precautions may be dangerous for the machine
and the operator.
Figure 2
CAUTION!
Check that your electrical mains voltage corresponds to the range indicated on
on the data plate.
Connect the pump to the power supply.
Inlet Flange
To Next Page
Loading...
Need help?
General
