Agilent Technologies U1251A - Measuring Resistance, Conductance and Testing Continuity

44 Agilent U1251A/U1252A User’s and Service Guide
2 Making Measurements
Measuring Resistance, Conductance and Testing Continuity
1 Set the rotary switch to Ω nS.
2 Connect the red and black test leads to input terminals Ω
and COM respectively.
3 Probe the test points (by shunting the resistor) and read
the display.
Figure 9 Measuring resistance
CAUTION
Disconnect circuit power and discharge all high-voltage capacitors before
measuring resistance to prevent possible damage to the meter or the
device under test.
MAX