28 Single-wheel power hoe 3100 Edition 03.95
4. Commissioning and Operation
1 Special protective hood for ridging
2 Ridger
3 Clamping screw for ridger
4 Adjusting screw for slant adjustment
5 Slip heel
6 Clamping screw for mouldboard
adjustment
7 Tilling tool
Ridging with Ridger
Required Accessories
Tilling tool
Alternatively 28, 32 and 38 cm
Front weight
Item no. 3128 011
Ridger with protective hood
Item no. 2152 011
Mounting Ridger
l
Remove hood.
l
Mount special protective hood (1) for
ridging.
l
Insert stem of ridger (2) into skid beam
pocket of hood and fasten with hexago-
nal screw (4).
l
Pre-adjust slanting of ridger with hex-
agonal screw (3). Ridging depth depends
on the slanting angle of the ridger – the
more the ridger slants backwards the
deeper is the working depth.
l
Mount front weight.
Ridging
l
Commission single-wheel power hoe
as described in “Tilling”.
l
After a few metres of cultivation, ad-
just the desired ridging depth. For this
purpose, adjust slanting of the ridger and
the height-adjustable slip-heel (5) with
hexagonal screw (3).
l
Adjust the desired ridging width by
adjusting the mouldboards with the
clamping screw (6).
To Next Page
Loading...
