Edition 03.95 Single-wheel power hoe 3100 35
5. Maintenance
Storage
For longer periods of no operation
prepare the single-wheel power
hoe for storage. Proceed as fol-
lows:
a) Clean thoroughly
Repair paint coat, lubricate lubrication
points and operate single-wheel power
hoe for a short time. Then spray all shin-
ing parts, in particular hoeing tools, with
Bio-slushing oil.
b) Engine preservation
l
Drain fuel completely or add fuel sta-
bilizer (AGRIA No. 673 50).
Method: Fill fuel tank, add anti-corrosive
and stabilizing liquid (amount “ON” sta-
bilizes 4l of fuel). Let engine run for
approx. 1 minute. (Observe enclosed
instructions).
Close fuel tap and let engine run until it
slowly comes to a complete stop due to
lack of petrol. This ensures the carburetor
to be empty and no resin residue to de-
posit.
l
Fill a tea-spoon (approx. 0.03l) of en-
gine oil into spark plug opening. Slowly
crank engine every 2–3 weeks (spark
plug connector disconnected).
W
Keep anti-corrosive agent
and stabilizer out of reach of
children at all times. Do not
inhale vapours! In case of sickness and
vomiting see a doctor immediately! In
case of eye contact with liquids, rinse
eyes thoroughly.
c) Drive-wheels
Support drive-wheels in such a way that
tyres have no ground contact. Pneumatic
tyres are quickly destroyed, if left stand-
ing under load and unsupported.
d)
Do not park the machine in humid
rooms, in rooms where fertilizer is stored,
in stables or adjacent rooms because of
severe corrosion.
e)
Protect machine with cloth or a simi-
lar cover.
To Next Page
Loading...
