CHAPTER 7
36 37
MYCHRON5
In order to accomplish these tasks, Race Studio 3 has to be used as clarified in the
following figure.
As you can see by the picture above, one device called “MyChron5 ID 43008208” is
switched from AP mode to WLAN mode.
The network name is “network_2,” and it is not working in open authentication mode
since it is protected by a network password.
In order to get the connectivity to the device, the user’s PC also has to be
authenticated to the same network, as clarified in the following figure.
Once the user’s PC is authenticated to the same network called “network_2,” it can
see the AiM device previously configured to gain access to the target network.
In the previous picture, two AIM devices are connected to the WLAN network_1.
MANUALE IMPAGINATO.qxp_Layout 1 25/11/15 16:04 Pagina 41
To Next Page
Loading...
