28
Introduction
4.4.3 Add a station
Use this flowchart to add a station.
Support Tool is needed to configure the system using this flowchart. Install Support Tool, and set for IPv6. For set up
information, refer to "IX Support Tool Setting Manual."
1. Connect a PC to the station to be added.
Connect stations one at a time to avoid IP address conflict.
“Connecting to a PC (→page 44)”
2. With the default IPv4 Address, log in to the Web server of the station to be added.
“Log in to the Web server of the station to be configured (→page 45)”
3. Set "Static / DHCP" to "IPv6 Stateless."
“Static / DHCP (→page 66)”
The station restarts and an IPv6 address is automatically configured. If the IP address fails to be automatically configured, it
will become "FDC2::7000." If this happens, cycle power to the station, and then the IP address will be automatically
reconfigured.
4. Search each station to be added with Support Tool for its IPv6 address.
5. Log in to the Web server of each station with the IPv6 addresses identified.
“Log in to the Web server of the station to be configured (→page 45)”
6. Configure “Language (→page 63)”.
Click [Update] to update the settings.
7. Configure the station.
"Configuring the station" “Configuring the Station (→page 59)”
8. Add data to other stations and software if required.
9. Done.
To Next Page
Loading...
Need help?
General
