31
How to use the device
To make a call / To respond to an incoming call
3
Note
• The call is placed using the priority that was set during
programming.
• The outgoing call timer and the calling tone count may vary
depending on the settings.
• When calling a VoIP Phone, this will be the shorter time of
the time set for "Call Timeout" and the call duration set on
the IP-PBX.
• The calling tone may not sound, depending on the settings.
• Depending on the settings, communication sounds may
play from separately installed speakers.
• A call start notification tone or message may play when the
call starts, depending on the settings.
• If the call duration that was previously set on this station
elapses, the call will automatically end. A notification tone
will play approximately 10 seconds prior to the call ending.
The notification tone may not play, depending on the
settings.
• If a page with a higher priority is received from another
station while making an outgoing call or during a call, the
outgoing call or call will be interrupted and the station will
switch to the page.
• If call recipients include a VoIP Phone configured to
automatically take the call, that VoIP Phone will answer.
To Next Page
Loading...
Need help?
General
