70
Settings and Adjustments
Configuring the device on a PC
4
■ Send Test Email
Send a test email to the address set in “Email Addresses (→page 67)”.
How to send a test email
1. Click [Send].
2. The following email message will be sent to the address you set up.
Example of sending an email message:
When sending a test email from this device (Station Number: 003, Station Name: Door Station 3, Location: 2F West).
■ Additional Settings (IX-DV and IX-DVF(-*) only)
Source △△△△@△△△△△.com
Date and time 7:22 11/20/2018
To
CC
xxxx@xxxxx.co.jp
Subject 003 Door Station 3 Test Email
Description Test Email sent at "20181120 15:22:46."
Station Number: [003]
Station Name: "Door Station 3"
Station Location: [2F West]
Important
• "UTF-8" encoding is used for "Subject" and "Image Filename." Characters may display incorrectly depending on the email
client. To avoid this, set the encoding method to "UTF-8."
Entry Description Settings Default values
Attach Image Configure whether to attach an image file
captured on camera to the email message,
when sending an email message via "Email
Event Trigger" during a normal outgoing call,
priority outgoing call, or urgent outgoing call.
• Enable
• Disable
Disable
Image Filename Configure the name of the image file when
using "Attach Image."
1 - 64 alphanumeric
characters
-
Important
• "UTF-8" is used to encode the "Image Filename." Characters may display incorrectly depending on the email client. To avoid
this, set the encoding method to "UTF-8."
To Next Page
Loading...
Need help?
General
