Aiphone IXW-MA - For IPv4 Address with DHCP

14
Introduction
4.2 For IPv4 Address with DHCP
4.2.1 Create new data
Use this flowchart to create a new setting file, for example, when installing a new system.
Important
• Due to the architecture of the IX system, DHCP configuration is only recommended for network environments utilizing
managed (static) IP address leasing. For how to set up the DHCP server, refer to its manual.
• Save the setting file after configuring the system. Refer to
“Settings File Backup (→page 90)”.
• If the setting data is not saved, it may be impossible to restore if post-installation service or maintenance is required.
1. Install the DHCP server.
2. Connect PC to the station to be configured.
The default IP addresses of the stations are identical. Connect one at a time.
“Connecting to a PC (→page 41)”
3. Log in to the web server of the station.
“Log in to the Web server of the station to be configured (→page 42)”
4. Set "Static / DHCP" to "IPv4 DHCP."
“Static / DHCP (→page 58)”
The station restarts and the IP address that is configured with the DHCP server is assigned. If the IP address fails to be
automatically configured, it will become "192.168.1.160." If this happens, cycle power to the station, and then the IP address
will be automatically reconfigured.
5. Log in to the web server of the station with the assigned IP address.
“Log in to the Web server of the station to be configured (→page 42)”
6. Set “Language (→page 54)”.
Click [Update] to update the setting.