9
Introduction
4.1 For Static IPv4 Address
4.1.1 Create new data
Use this flowchart to create a new setting file, for example, when installing a new system.
Important
• Save the setting file after configuring the system. Refer to “Settings File Backup (→page 90)”.
• If the setting data is not saved, it may be impossible to restore if post-installation service or maintenance is required.
1. Connect PC to the station to be configured.
The default IP addresses of the stations are identical, so connect and configure one at a time.
“Connecting to a PC (→page 41)”
2. Log in to the web server of the station to configure.
“Log in to the Web server of the station to be configured (→page 42)”
3. Set “Language (→page 54)”.
Click [Update] to update the settings.
4. Configure the station.
“Configuring the Station (→page 51)”
5. Configure other stations in the same manner.
Refer to each station's Web Setting Manual.
6. Complete.
To Next Page
Loading...
