90
Configuring the Station
5.3 Settings File Backup
Back up the setting file so it can be used to restore the system.
How to back up the setting file
1. Click [Download Settings File].
2. Specify the location to store the setting file.
• The default file name is "GetConfig." Change the file name if needed.
How to restore setting file
1. Click [Browse].
2. Select the setting file to be restored, and click [Open].
3. Click [Restore Settings File].
4. Click [OK].
• Click [Cancel] to cancel the restore process.
Important
• When a setting is changed, back up the setting file. With the backup setting file, the settings of a replaced station can easily be
restored.
• The following items are not backed up. Save them separately from setting file.
– SIF data uploaded in
“SIF (→page 79)”
– Certificate data uploaded in
“SSL Certificate (→page 85)”
– Certificate and other data uploaded in
“IEEE 802.1X (→page 86)”
Important
• When setting data is restored (including updating the IP address), the station will restart. This may take approx. 10 minutes in
total.
• Data for the following items cannot be restored using this procedure. Instead, upload from each item.
– SIF data uploaded in
“SIF (→page 79)”
– Certificate data uploaded in
“SSL Certificate (→page 85)”
– Certificate data and the like uploaded in
“IEEE 802.1X (→page 86)”
To Next Page
Loading...
