20
Introduction
4.3 For static IPv6 address
4.3.1 Create new data
Use this flowchart to create a new setting file, for example, when installing a new system.
Important
• Save the setting file after configuring the system. Refer to “Settings File Backup (→page 90)”.
• If the setting data is not saved, it may be impossible to restore if post-installation service or maintenance is required.
1. Connect PC to the station to be configured.
The default IP addresses of the stations are identical. Connect one at a time.
“Connecting to a PC (→page 41)”
2. With default IPv4 Address (192.168.1.160), log in to the Web server of the station to be
configured.
“Log in to the Web server of the station to be configured (→page 42)”
3. Set "Static / DHCP" to "Static IPv6" and configure "IPv6 Address."
“Static / DHCP (→page 58)”
The station will be restarted with the assigned IPv6 Address.
4. Configure IPv6 addresses for other stations in the same manner.
5. Log in to the web server of each station with IPv6 address.
“Log in to the Web server of the station to be configured (→page 42)”
6. Set “Language (→page 54)”.
Click [Update] to update the settings.
7. Configure the station.
“Configuring the Station (→page 51)”
Refer to "Web Setting Manual" for each station.
8. Complete.
To Next Page
Loading...
