86
Configuring the Station
4.7 IEEE 802.1X
Configure the settings for IEEE 802.1X authentication.
■ IEEE 802.1X
■ EAP
■ EAP User Name
■ EAP Password
Important
• When the "IEEE802.1X" setting is changed, the station will restart. It may take around 10 minutes for the device to finish
restarting. The station cannot be used until it has finished restarting.
Description Select Enable / Disable for IEEE802.1X function.
Settings • Enable
• Disable
Default values Disable
Description Select the EAP method for IEEE802.1X authentication when “IEEE 802.1X (→page 86)” is set to
"Enable".
Settings • TLS
• PEAP
Default values TLS
Description Set the EAP User Name.
Settings 1-32 alphanumeric characters
Default values —
Description Set the EAP Password when "EAP" is set to "PEAP".
Settings 1-32 alphanumeric characters
Default values —
Note
• The "EAP Password" is shown as "●●●●●" in the Settings window.
To Next Page